DIY-er Sean Billups has transformed his old Google Pixel 3A into a multispectral camera that can view in Ultraviolet (UV) and Infrared (IR) wavelengths that are not normally visible to the human eye.
Multispectral cameras are commonly used by NASA to image the Earth to investigate farmland and drought conditions and look for areas of climate change and erosion. Scientists use the same technology to inspect layers and underdrawings of paintings in order to determine their condition and for conservation purposes.
That latter use case is exactly what Billups had in mind when he decided to tackle this project. He designed and 3D printed a wheel that fits over the camera on his Google Pixel 3A and turns it into a multi-spectral imager which can view in UV, IR, and normal visible light.
Billups chose the Pixel 3A for this experiment because it has a highly rated imaging sensor despite its age and supports some great camera apps to process the pictures he would take with it. Camera image sensors can be sensitive to IR light and ultraviolet light. This was a challenge. These camera image sensors require special filters that filter out UV and IR light in order to see the available light. The filter for smartphones is attached to the lens.
He opened up his phone and carefully removed the camera lens and then he applied a little targeted heat to loosen up the glue that holds the filter onto the camera lens.
After the glue had hardened, attach a small piece of plastic to the filter. Once it set, grab hold of the filter and take it out. He then put the lens into the assembly of the camera and sealed the phone.
It sounds simple when reading it, but in reality, with such tiny screws and parts, this procedure isn’t for the faint of heart. Moreover, it took a lot of trial and error for Billups to remove the filter without damaging the lens or the camera module itself.
Once the hard part was finished, Billups 3D printed a selection wheel with filters embedded in it that would allow for different wavelengths of IR, UV, and available light to be captured. He attached the wheel with a screw on the back of his phone so that he swap among the different filters by spinning the wheel.
Armed with four different filters, Billups took his new handheld multispectral camera to a gallery at a museum and pointed it at some of the paintings.
Billup was able to see what the light reveals at various wavelengths.
Now that he’s proven the concept works, Billups plans to expand his camera design with more enhancements such as IR and UV LED lights, magnifying lenses, and additional sensors like spectrometers.
Anyone interested in trying the project for themselves can find the steps and necessary details on Billups’s Hackaday project page.
Image credits: Photos by Sean Billups